Re: Steering Wheel Removal

[Herb <zephyr9900@xxxxxxxxxxx>]

Your going to need two small jeweler screwdrivers or eyeglasses repair screwdrivers, push them into the small slots on ether side of each terminal releasing the tabs or barbs.  The terminal will pull right out the back.  Make sure you write down the position in the plug each color wire went to so your not hit and missing!  Also I would fish the wires into the steering column before you install the plug it will make your job SOOOO much easier.  Inspect each terminal when installing the new switch that the barbs are extended and will catch good and not get pushed out when putting the plugs back together.  Some dialectic grease will go a long way to help also.

 

 

 

 

-------Original Message-------

 

From: Dave64

Date: 7/8/2013 10:20:36 PM

To: 1962to1965mopars@xxxxxxxxxxxxxxxx

Subject: Re: Steering Wheel Removal

 

They're the same, so that's not a problem.  They're the round ones.  They're stubborn and won't come out so far.  It looks like they're barbed, but I haven't come up with the right technique to get them to release yet.

 

Thanks,

 

Dave
'64 Belvedere 2DHT
318 Poly, Push Button Auto

From: Herb <zephyr9900@xxxxxxxxxxx>
To: 1962to1965mopars <1962to1965mopars@xxxxxxxxxxxxxxxx>
Sent: Monday, July 8, 2013 9:26 PM
Subject: Re: Steering Wheel Removal

I believe 64 was a transition year.  Can you get a photo of the plug on the end of the t sig switch?  Their are flat ones and I believe round ones, make sure your new switch has the same ends as your old one.

 

 

 

 

-------Original Message-------

 

From: Dave64

Date: 7/8/2013 8:49:52 PM

To: 1962to1965mopars@xxxxxxxxxxxxxxxx

Subject: Re: Steering Wheel Removal

 

I borrowed a puller from work.  It didn't put up much of a fight, so it's off now.  I also started installing a new Daniel Stern turn signal switch and wiring.  Now I'm trying to figure out how to get the little pin connectors out of the connector under the dash so I can put the new wires with connectors in it.

 

Dave'64 Belvedere 2DHT318 Poly, Push Button Auto

 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.