Hi everyone, Just when I thought I was done with the restoration in time drive it before the snow flies --- It ran great on 3 short drives, then it started running progressively worse until it quit altogether. There was probably less than 1 hour total run time on the restoration. The whole time it was running around the neighborhood I noticed that the ammeter was pegged on the high side. I could turn on all the accessories and get it down about half charge. We rolled up our sleeves. BTW, the car was converted to 1956 = 12 v components in the late 60’s We eliminated fuel as the problem but we did find some ignition gremlins. Coil was switched, no change, ballast resistor and other components switched out and it still would not start or run. Then we put in a complete junk yard distributor in and it started right up, idled and ran great. Today I changed the condenser in the rebuilt 1st distributor and put it back in. It still starts, idles and runs great. The very high rate of charge is still there – is this a problem? Could it have contributed to the condenser failure? Is there anything else I need to investigate? Thanks as always …Jack Jack C. Boyle Enjoying the same C300 since 1967
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/006701d7bbc8%24f0d80060%24d2880120%24%40gmail.com. |
Back to the Home of the Forward Look Network
Archive Sitemap
