converters/ fluid couplings
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

converters/ fluid couplings



> In fact, during the 60's when these transmissions were built, the
potential of
> a lockup converters was well known in the industry.  However, everybody
> realized that the improvement that such a device would offer did not worth
its
> cost (because the converter slippage is very low most of the time).  In
modern
> times, the engines lost torque and the requirements in performance
increased,
> so they started installing high stall converters.  Also, overdrive
> transmissions became common.  Overdrives tend to load the engine at low
speeds
> where slippage is high.  Now, the potential benefits of the lockup are
higher,
> so they are used on virtually all modern cars.

Don't modern cars include some 'either/or' control logic?  IOW, first OD is
engaged, and then lockup.  Lockup is first to let go, then the unit
downshifts as needed.

>
> Now, why did the 440s in 78 had lockup transmissions?  Oil crisis may be?
As
> said, I cannot verify any mileage advantage of my lockup equipped LeBaron.
>

That is encouraging news for anyone who is concerned about gas mileage who
is using an older trans.

John





Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.