On Oct 9, 6:50 pm, "Ollie" <
satellite1...@xxxxxxxxxxx> wrote:
> Got to keep working Steve.....snow before you know it.
> Brutis was looking good when I last visited your shop.
> Planning on coming to the Geezer Drags next year...you can take me for a
> ride.
> Ollie
>
>
>
> -----Original Message-----
> From: MO
> Sent: Tuesday, October 09, 2012 1:36 AM
> To: The 1962 to 1965 Mopar Mail List Clubhouse
> Subject: Re: Progress report on my 64 Dodge project
>
> Part 3 I finally broke down an put a small air cond. in the shop
> finished assembly on the engine and painted it and the bellhouse.
> Bought a new Centerforce clutch set. Took my two 4 speeds to a friend
> for inspection. Both were very good. I ordred gaskets and seals from
> Brewers. Just today I got a call that the tranny will be ready by the
> weekend. I am now waiting for another friend to come set the
> bellhouse run-out with the adjustable dowels. Hopefully the engine
> and tranny install will be soon. I pre fit everything and have all
> the correct clutch linkage and clutch fork.
> This past weekend I overhauled the steering colume and today
> installed it and installed the dash guage assembly. .I have been
> waiting for a list member to contact me about a voltage limiter that
> he was looking for , but I gave up on him. Saturday I took it to a
> local RadioShack store had the mechanical guts taken out of it and a
> resister instaled to cut the voltage to the guages. I had called Joe
> Suchy, but at this time he did not have any. . I ordered some other
> parts from him , and I say he is a top notch person to deal with.
> Non- better.
> It sure takes a lot longer to put a car together than to take it
> apart. . Like a Rolls Royce-- each part finised and installed by
> hand , one part at a time!
> My goal is to have it moving under it's own power before the first
> snow-- and it is below freezing at night here!....................MO
>
> On Oct 9, 12:41 am, MO <
mic...@xxxxxxxxxxxxxxx> wrote:
> > Part 1 I don't know where I was on the project last time I
> > updated. Last Spring I got the body all straightened, primed and the
> > hood, door openings, and trunk lid painted on the inside and edged.
> > The two doors will be done later. Frame connectors welded in. Dual
> > Master cylinder installed. Dash painted white on the underside to make
> > it easier to see the wireing. Dash installed. Clutch and brake pedal
> > assembly painted and installed. Front windshield installed
> > temporarily - new one and gasket later. ..............MO
>
> --
> --
> --
> Please address private email -- email of interest to only one person --
> directly to that person. That is, email your parts/car transactions and
> negotiations, as well as other personal messages, only to the intended
> recipient. Do not just press "reply" and send your email to everyone using
> the general '62-'65 Clubhouse public email address. This practice will
> protect your privacy, reduce the total volume of mail and fine-tune the
> content signal to Mopar topic. Thanks!
>
Back to the Home of the Forward Look Network