pushrods

[William Harrison <bbjt3@xxxxxxxxx>]

Couldn't sleep last night so I went out to the garage and fired up the heater and started doing some pre-fit work.
stuck my roller cam in and slapped a head on the block with my roller rockers.
Stuck a new adjustable push rod in and it is too tall.
Slid a stock rocker on the shaft and the only difference is that the stock rocker is wider.
The roller lifter looks to be the same depth as a stock one.
Stuck on this one.
Anybody have some magic that they can pull out of the hat.
I am thinking of maybe using push rods from a small block but they might still be too short.

Later
Bill Harrison
65 Coronet 2 dr post


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.