Block Machining cost

[William Harrison <bbjt3@xxxxxxxxx>]

Wow!!!! 
What a shock when I went to pick up my 383 block from the machine shop today.
Just wanted it bored .60 @$18 per cylinder,line bored and cam bearings installed.
Before you know it, the block needed to be decked .10 and my new billet main caps needed to be shaved and the lifter bores needed to be honed, yada yada yada.
I was going to install the pistons on the rods and install new freeze plugs but I didn't tell him I was going to do that so another few dollars.
The little things kept creeping in and before you know it; I just paid $1260.00 for that sucker.
I have to keep this from my wife or I am dead!!!!
I will post pics of the build of this 496" stroker as it gets assembled.
Later
Bill Harrison 
65 Coronet 2 dr post


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.