Re: [Chrysler300] driveshaft boot

["RONALD BUSENHART RB1937Ford@xxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Sent from my iPad

On Apr 27, 2019, at 11:18 PM, RONALD BUSENHART RB1937Ford@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

Yes remove the drive shaft and clamp it in a vise. I have replased 100s of them.IWorked for Chrysler, The proper way to do it is to use Chrysler’s special tool and press the pin out but lve done many of them by cutting the old one off and not removeing the pin and   Greasing the new boot inside and outside with wheel bearing grease and pulling it through from the front side very carefully with a pare of players then clamp it.

Sent from my iPad

On Apr 27, 2019, at 12:37 PM, LUCKYL46@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

hi gang. looking for rubber boot for drive shaft for 1962 sport, and how does it go on.  does the shaft have to come down  thanks.   joe luciano  howard beach ny...

__._,_.___

---

Posted by: RONALD BUSENHART <rb1937ford@xxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___