Re: [FWDLK] 413 Chrysler with 8 to 1 Compression Ratio?????
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] 413 Chrysler with 8 to 1 Compression Ratio?????



Can you bore the 413 block to .060?  .030 will add about 6-7 CI, so you need
to go like .050 on it to get a stock 426 bore.

Bill K.


----- Original Message -----
From: "Ron Allyn Swartley" <Archangel1390@xxxxxxx>
To: <L-FORWARDLOOK@xxxxxxxxxxxxx>
Sent: Wednesday, October 22, 2003 8:08 PM
Subject: Re: [FWDLK] 413 Chrysler with 8 to 1 Compression Ratio?????


>
>
> Curtis,
>
>     You really did do your homework.!!!!!! I agree the 413 pistons are not
> readily available but I would hunt until I found them or punch the 413 out
to
> 426 and used their pistons. If the motor is being torn completely down I
feel
> that is the route to go. I feel if we talked to a guy with a 62 or 63
Ramcharger
> and he is rebuilding it he is not going to go to 8.1 CR.  However he may
be a
> little reluctant to tell us his sources.
> Thank you for the additional information.
>
>
>   Ron
>

-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
Over 25,000 pages of archived Forward Look information can be easily searched at
http://www.forwardlook.net/search.htm  Powered by Google!



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.