Re: IML: plates on the trans mount

["jsadowski" <jsadowski@xxxxxxx>]

The shims for the drive shaft angle should be under the center bearing, not 
the trans mount.
John
----- Original Message ----- 
From: "Markku Jaakkola" <impcyclope2@xxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Wednesday, May 25, 2005 3:07 PM
Subject: Re: IML: plates on the trans mount


> My friend - who has 1962 custom coupe - is also working with the 
> transmission and he told me that he had also same kind of shim-plates 
> between the transmission and transmission rubber mount. I'm sure that they 
> were used to chance the driveshaft angle, so I placed them back like they 
> were before.
>
> Markku
>
> mike sutton <mikanlin62@xxxxxxxxxx> wrote:
> Any chance those little plates on the trans mount were used as shims to
> change a driveshaft angle? The FSM shows shims on the center bearing
> support but I dont recall seeing any on my 62 or on the two 63's that I
> have owned. There is quite a bit of text in the service manual regarding
> the indexing and the anglularity of the prop shaft, maybe someone in the
> past had tried to correct a problem.
>
> Mikey
> 62 Crown Coupe
>
>
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>
>
>
> ------------------------------------------------------------------------
> Markku Jaakkola
> impcyclope@xxxxxxxxx
> Finland
> 1962 Imperial 2d Ht Crown
> 1957 Imperial 4d Ht Crown "single headlight"
> ------------------------------------------------------------------------
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com 




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm