RE: IML: Budd Brakes, again

["Rob McCall" <Rob_Mopar@xxxxxxxxxxx>]

Klebert,

I'm doing the conversion on my LeBaron.  I have all the parts now.  Other
than the pieces needed from a donor vehicle, everything else came from
AutoZone.  I'll be taking pictures of the conversion as it happens.  I'll
see if I can compile a parts list too.

As for the Budd pads, save what's left of the old pads.  Namely the backing
plates.  There are services out there that can apply new friction material
to the plates.  I haven't used them myself, but some of my road racer
friends have.  They get different compounds for track use, etc., but the
premise is the same.

Rob McCall
'67 LeBaron

-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx
[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Klebert L. Hall
Sent: Friday, January 07, 2005 9:55 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: Budd Brakes, again

   The other day I blew a flexi-line on my front brakes, and took my car in
to get it fixed. The line(s) were no problem at all, but my brake pads were
getting thin, so we tried to find them - no joy. I finally got some from
(sigh) Ebay / Mitchell.

   I would like to advise folks that the D 10 pads now seem to be the major
chokepoint on keeping Budd discs in service - if you have a Budd equipped
Imperial that you intend to drive significantly, I'd get some spare pads
while you still can. Rotors last a good while, and there's always the Supra
conversion. Calipers seem to be readily available. The pads wear relatively
quickly, and I couldn't find any source other than limited NOS supplies.

   Now for my questions:
   Could somebody who's done the '70-'73 Bendix conversion carefully list
what is required, what can be bought new, and what has to come from salvage?
I'm no expert on this sort of stuff, so don't assume I'll understand
anything non-specific. I've looked through the explanations on the website,
and found them sort of confusing.
   Though I'd kinda like to keep the Budd system on the car, it's beginning
to look like that might be impossible in the long term, and I want to be
prepared.

   Does anybody know a good place for getting brake pads re-lined,
preferrably in New England? This seems like it might be the only route to
keeping the Budd brakes on the car.

   Is there a good source for the D 10 pads I'm just missing? Raybestos no
longer lists them, NAPA / Parts America / Autozone all list the D 85
instead, I can't even buy calipers 'loaded'.


  Thanks for any and all help.
    -Kle.
    '69 Crown 4DHT




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm