Looks like your right bar is a left. The right bar should be an even
number. Bars can be installed either end front/back, but there is a right
and a left.
The three digits are the last three numbers of the part number, Cannot
locate a bar ending in 317 or 217.
However, the standard bars should be 510 (R) and 511 (L) while the
heavy-duty bars should be 516 (R) and 517 (L)
A bar stamped 522 will not fit an Imperial - it is for a Dodge Polara or
Monaco.
Bill
Vancouver, BC
----- Original Message -----
From: BOBSMOPAR
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tuesday, March 02, 2004 7:17 PM
Subject: IML: 68 t-bars
Hi All.
Tonight I pulled the isolator bar out of the Imperial.
I then tried to turn the bars a little to mate them to the adjusting bolts
but they would not move do I need to loosen the nuts that hold the lower a
arms on the cross member.
I also checked the numbers on the bars.
On the right one it has stamped on it 317.
On the left one it has a L and 217 on it.
I have one nos bar for the right side it is stamped 522 R can I use 1new
bar and 1 old bar on this car.
Thanks for any help you can give.
I thank all that replied so far.
This list has been a great source for info and parts.
Bob
68 Imperial
Back to the Home of the Forward Look Network