speed nuts
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

speed nuts



Title: Message
Ernie, Where do you get 'thumb grade sealer'?
 
Kerryp
http://dte.net/57imperial
KaP Imperial Services - Patch Panels, Metalshaping, Restoration
Manufacturer of high quality Wheeling Machines
----- Original Message -----
Sent: Saturday, December 06, 2003 12:06 AM
Subject: RE: IML: speed nuts

DumDum aka thumb grade sealer would work great and be very close to factory.
Ernie
-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Bob
Sent: December 3, 2003 11:42 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: speed nuts

Does anyone know the correct sealant used in the hollow of speed nuts that hold on trim pieces?  I don't want to use anything with too much adhesive as the tangs on pot metal pieces are easy enough to break off as it is, but need to seal this source of water and moisture mitigation.  Years applicable are early 60's (1962), and there may have been more than one sealant used.  Thanks!!
 
Bob
 

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.545 / Virus Database: 339 - Release Date: 11/28/03


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.