speed nuts

["Ernie Stepney" <estepney@xxxxxxxxx>]

Title: Message

DumDum aka thumb grade sealer would work great and be very close to factory.

Ernie

-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Bob
Sent: December 3, 2003 11:42 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: speed nuts

Does anyone know the correct sealant used in the hollow of speed nuts that hold on trim pieces?  I don't want to use anything with too much adhesive as the tangs on pot metal pieces are easy enough to break off as it is, but need to seal this source of water and moisture mitigation.  Years applicable are early 60's (1962), and there may have been more than one sealant used.  Thanks!!

 

Bob