Hi Dick.
Thanks for the info.
I went back over to my garage to day and stared tracing the wires and
checking for shorts.
What I found out is that there is two different wires with the same kind of
plug on them and I had the wrong wire plugged in.
I now have all the windows working.
Thank you for your help and as always this list a good tool for are cars for
parts and for help when we run into a problem.
Thank you.
Bob
----- Original Message -----
From: "Dick Benjamin" <DickB@xxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Sunday, May 19, 2002 9:48 PM
Subject: Re: IML: power windows
> You've got a problem in the master switch, or the wiring to it. If the
> windows move without operating the switch, obviously, 12 volts is getting
to
> the wires to the motor, and this should not happen if you are not
operating
> the switch. Take your wiring diagram and a test light or VOM and figure
out
> where things are going wrong. Be sure to disconnect the battery
> immediately, since you might have a fire if there are some wrong
> connections. You can unplug the motor wires while you troubleshoot, this
> will prevent burning up the motors.
>
> Dick Benjamin
> ----- Original Message -----
> From: Robert Hanekamp <bobsmopar@xxxxxxxxxxxxxx>
> To: <mailing-list@xxxxxxxxxxxxxxxx>
> Sent: Sunday, May 19, 2002 8:11 PM
> Subject: IML: power windows
>
>
> > Hi All.
> > While working on my 68 imperial tonight I ran into another problem.
> > I have put all the windows back in and hooked them up.
> > I can only get the power vent windows and the right rear window to work.
> > The front windows when I plugged in the wires to the motors the windows
> came
> > down on there own and will not go back up.
> > I can unplug the motors and use a battery and the windows will work.
> > Any help would be great July 12th is getting close.
> > Thank you.
> > Bob
> >
> >
> >
Back to the Home of the Forward Look Network