Getting to the fan motor on my '63

["WC Roddick" <roscoe1@xxxxxxxxxxxxxx>]

Does that go for the '64 as well?????


----- Original Message ----- 
From: "Chris Hawkins" <imperial1966@xxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Saturday, May 11, 2002 4:05 PM
Subject: Re: IML: Getting to the fan motor on my '63


> It it not as difficult as you might imagine.  But
> almost.  And no A/C plumbing needs to be touched.
> 
> 1. After removing (AND LABELING!) from the under-dash
> plenum all vacuum hoses, cables, and vacuum motor
> actuator rods (don't forget the recirculation door far
> above the trans hump), follow directions in shop
> manual for removing ground wire and connectors for
> blower motor.   
> 
> 2.  Remove entire underdash duct housing.  It is held
> in by only three screws as I recall. 
> 
> 3.  Once removed, it is simple to swap out the blower
> motor.
> 
> 4.  Install as above, being sure to align the
> blower-to-firewall gasket and A/C duct hoses.
> 
> Good luck!
> 
> Chris H.
> 
> 60 NY T&C
> 66 Crown Convertible
> 66 LeBaron