I've done the same thing in my '65 Crown. Just use the left/right leads for the FORWARD set of speakers and run one lead to the back speaker and one to the front speaker under the dash. Then you use the left/right balance for the fade control. Sounds great in my ride... Good luck! CHRIS WALTER Modesto, CA --- JAY D'ANGELO <cadij@xxxxxxxxxxx> wrote: > OK audiophiles - this will be easy for you: > > I'm hiding a new stereo under the dash, but I'm only > using the front and rear speakers. How do I wire > them, since there are four speaker wire runs? > > Connect both front pos leads together and then to > the speaker and the same with the output leads from > the rear and connect the negs togethe? If I do > that, then I will have fade control. Sound right? > been a long time since I've played with speaker > wires. > > Jay D'Angelo > 64 Iml Cvt > Las Vegas > _________________________________________________________________ > Check the weather nationwide with MSN Search: Try it > now! > http://search.msn.com/results.aspx?q=weather&FORM=WLMTAG __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm