The pump rotors tend to wear into the housings causing excessive clearance hence low oil pressure hence slipping clutches hence that was fun let's do it all over again. I found a machine shop through a transmission shop I deal with in the shop who machined the housing, (bore and face the same amount) and rotor to clean them up for an absolutely factory correct clearance. Ask around, it cost about $250 Cdn. Ernie and The Black Bitc_!!\ ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm