Re: IML: 1967 Crown Imperial Reverse Lights

["Stevan Miner" <miner@xxxxxxxxxxx>]

On the drivers side of the transmission you'll find a three wire switch just below the shift linkage. With the key on, there should be 12+ volts to one of the outer wires in the connector. If there is, try jumping a wire to the other outer wire and see if your reverse lights come on. If so the switch is probably bad. There should be continuity between the two outer pins when the shift lever is in reverse. The middle pin is for your neutral safety switch. If you don't have power at the switch, you'll need to find out why. Hope this helps.

Stevan Miner

Miner Auto Service

Winnebago MN

----- Original Message -----

From: ADMBLK@xxxxxxx

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Sunday, June 26, 2005 7:03 PM

Subject: IML: 1967 Crown Imperial Reverse Lights

I'm having some problems with my reverse lights.. basically they don't come on.  Any ideas on where to trouble shoot this from?  I have checked and replaced bulbs so far..

Thanks..