63 Plymouth - 3 and 4 speeds

[Gary Futrell <gary.futrell@xxxxxxxxx>]

I'm sure this has been discussed before, but I've slept since then. I
read somewhere where you could only get a three speed manual in 63,
but a Chrysler book I have stated the four speed was available with
the 426 Max Wedge. I noticed in pictures that the 3 speed appeared to
have a round shifter handle and the 64 handles were rectangular. If
the 63 was available with a four speed, did it have a round or
rectangular shifter handle ? I have a 833 with Hurst shifter assembly
with push-in round shifter handle and a Hurst shifter assembly with a
64 rectangular handle. Just trying to decide which one to use.

By the way, got my new aluminum early B bellhousing and clutch
assembly parts in from Brewer's. The bellhousing looks great, almost
too good to install. Almost wanted to mount the bellhousing on the
wall, but my wife said it wouldn't look good in the kitchen. :)


   Gary F.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.