http://www.inlinetube.com/Prop%20Valves/pro_valves.htm has new proportioning valves if you don't have one already from a 1967 parts car. Gary H. > -------Original Message------- > > NO. You just need to get the correct proportioning valve, drum - drum, > disk - drum, disk - disk. Drum - drum in your case, the one from the 67 > Coronet will work just fine! > > > Herb > > _-------Original Message-------_ > The old single bowl master cylinder of death was leaking on my 65 Coronet > so I decided to upgrade to a dual one from a 67 Coronet. Question is, the > metal block where the lines split front to back only has 1 line going to > the MC. I am assuming there is a different block that would have 2 lines > out to the MC. I did a google search but found only proportion valves but > as of now I am keeping it drum/drum and they are for disc/drum correct? -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.