Two cents: use an electronic solid state voltage regulator. REGITAR #C524, WELLS #VR706, STD #VR101, BWD #R280, FILKO #VR369HD are some brands. Price them separately as the price used to vary a lot. The Standard 101 was about $23 last I recall from RockAuto. I think the Wells is chrome but there is a way to swap covers if original appearance is needed. Thanks, Gary H. > -------Original Message------- > > Since the cost of the test was zero, I was going to splurge at NAPA and get > both a new alternator and new voltage regulator which together seem to be > less than $100, perhaps changing the regulator first to see what that does. > My service manual says the original alternator was rated at 35 amps, so I > was going to get one of those. The only significant power draw I can > imagine this car has is the motor which moves the top. Does that sound > reasonable? I am I going to run into any trouble with a NAPA voltage > regulator replacing what's in there now? -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.