On Oct 15, 2012, Bill M <y1topbanana73@xxxxxxxxx> wrote:
I'm getting ready to get the machining done to my poly block and I'm a
little rusty on everything to do. If I remember correctly, I'll need
the following to get the block "ready for assembly"...
Hot tank/Degrease
Magnaflux
Bore & Hone to 3.950" (from 3.910" = .040")
Align Hone (do I need to do this??)
Clearance for 4" stroker crank (if needed)
Install New Cam Bearings
Am I missing anything?
Bill M
65 Coronet 500 'vert http://goo.gl/6xUS1
73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
21 Model T Depot Hack, 06 Mazda 3
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.