Re: 361 Engine suggestions

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Core/ freeze/expansion: use metal, brass if possible, in my 2c.  Sometimes the rubber core plugs with nut screw-down loosen up over time and need re-tightening. Also, sometimes the core location is so tight to get to that only the rubber type are easy to get in without pulling a lot of stuff, or the engine itself. 

Thanks,
Gary H.

>  -------Original Message------- 
>  
>  Check your freeze/expansion plugs.  I had 5 good ones and one that
>  starting pissing anti-freeze as soon as I tapped it.  They make rubber
>  ones with a nut that screws down that is much easier to get into the
>  engine while it is in the car. 

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.