Re: Running Warm

[Gary Wilson <gwwilson70@xxxxxxxxx>]

I forgot to mention that the Therostat  could be a problem.  When buying and installing new stats you must make sure that it has a weep hole in the side of the stat and also make sure to pop the center of the stat to make sure that it will open up.  I have seen them when brand new one would not open up right.   doubt that is your problem but you never know.  You have been driving it and works in cool weather??  If the new stat does not have a weep hole I would drill one it it.  That helps get rid of air bubbles. and you get more fluid in the radiator.

On Mon, Aug 8, 2011 at 8:40 PM, Richard Kinsley <leroar.kinsley058@xxxxxxxxx> wrote:

I agree the Milodon stat is the way to go. That is a good step froward and not too expensive. Did you paint the radiator? I've been wondering lately if in the past I had put too much paint on a radiator to "touch it up" and hindered the heat transfer? It seems like sometimes "overkill" is a killer :-)

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies 
===================================================================================================================================

On Mon, Aug 8, 2011 at 10:09 PM, Gary Wilson <gwwilson70@xxxxxxxxx> wrote:

I could be wrong but I think that you have a bad radiator.  Was is made in China.???  When it gets hot check the radiator its self to see if it has cold spots in it.  Just run your hand around the fins to see if it has cool spots. If so it is plugs up.  Maybe the fins are not allowing the water to flow correctly.  I assume that you have back flushed the engine.  Check the timing to be sure that it is not retarded.  Slow timing will heat an engine at slow speeds or just idling.  What year is the car and what size is the thing.  I have a couple of fan shrouds .
+

On Mon, Aug 8, 2011 at 5:44 PM, Bill M <y1topbanana73@xxxxxxxxx> wrote:

I installed a new and now my Coronet is definitely running warmer than
it should.

Here's the list...
318 Poly, Mild cam, 4-bbl
New 4-core copper radiator (US Radiator)
New 180 deg thermostat
New 16LB cap

No known issue with the water pump.
7-blade fan w/ clutch (seems to be working) ~1 inch from the rad.
No fan shroud

I swapped the previous 3-core radiator out because it was leaking.
With the 3-core setup (no shroud) it never got as hot as fast as it
does now. In fact after sitting just a few minutes at a light, this
4-core gets as hot as the 3-core rad did on only the hottest days in
July/August.

I know the lack of a shroud is 1 problem, but I just can't shell out
$250 +$50 for mounting hardware for it right now.

Considering I basically swapped only the rad, it should be acting
better than this.

Any thoughts?

Bill M
65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
73 Dart Sport, 00 Cherokee Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
21 Model T Depot Hack, 92 Accord, 06 Mazda 3

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--
Gwwilson

--

--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

--

--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

-- 
Gwwilson

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.