You can run solids on a hyd. cam. Just set the lash as a solid. No lifter pump up and more RPM. Run good pushrods, espically the exhaust, no flex or harmonics. --- On Sat, 11/13/10, William Harrison <bbjt3@xxxxxxxxx> wrote: > From: William Harrison <bbjt3@xxxxxxxxx> > Subject: Camshaft lifters > To: 1962to1965mopars@xxxxxxxxxx > Date: Saturday, November 13, 2010, 10:31 PM > > Ok > Here's my dumb question of the week. > Can you change hydraulic lifters out and install solid > lifters? > I just bought a nice used set of roller rockers along with > an almost new set of solid lifters and like the cam that is > in my car right now but it is hydraulic. > Any help appreciated. > Thanks > Bill > > > ---- > Please address private mail -- mail of interest to only one > person -- directly to that person. I.e., send > parts/car transactions and negotiations as well as other > personal messages only to the intended recipient, not to the > Clubhouse public address. This practice will protect your > privacy, reduce the total volume of mail and fine tune the > content signal to Mopar topic. Thanks! > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html and > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > >