A while back I questioned the torque spec of 65 ft. lbs. on the spindle nut. I just figgered where I got that spec. The wheel LUG nuts are spec.ed to that amount. . The spindle nut is tightened to 80-90 INCH pounds and then backed off one notch on the casteel nut. Bearing clearance when adjusted correctly is 0 to .003 tolerance. I hope this incorrect information has not caused any problems...................MO
{Steve Mick}
http://stevemick.shutterfly.com/pictures#Part%202
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
Back to the Home of the Forward Look Network
Copyright Š The Forward Look Network. All rights reserved.
Opinions expressed in posts reflect the views of
their respective authors.
This site contains affiliate links for which we may be
compensated.