I put slicks on the rear of my Dodge and it looks too high in the rear. I started looking at other cars with slicks and I noticed my front end is a lot lower than most "Super Stocks" and clones of them. I think the guy that built the car has the torsion bars cranked way down because the car is very low. I have not researched it yet on how to raise the front. Any tips or tricks and do you guys think that will cure my stance? Byron Picture of it with slicks are here: http://kingvoodoo.blogspot.com/2010/07/hurst-cheater-slicks.html ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.