Re: Under the dash

["MO ( Steve Mick)" <micher@xxxxxxxxxxxxxxx>]

Thanks Rich, I did get the panel loose from the dash but not very far. When 
I discovered the P problem, I quit for the day. Back at it tomorrow! 
Steering column is out..................................MO
----- Original Message ----- 
From: "Rich Kinsley" <rlkinsley@xxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Saturday, January 30, 2010 6:50 PM
Subject: RE: Under the dash


> Steve,  The harness is held in by some closed loops that can be opened
> by hand. The entire harness will lift out of them but there are many off
> shoots of the harness like an octopus that can be bothersome. You can
> pull the gauge cluster out the front and lay it down and work on the
> harness easier. It always helps to just remove the steering column too.
>
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> ===================================================================
> spigot2039@xxxxxxxxxxx wrote:
> > Are you sure it is a connected "P" bracket? That is, sometimes I've seen
> > a bracket that looks like a P but one side of the P letter's loop is not
> > connected to the straight part, so the loop actually can be pulled open.
> >
> > Thanks,
> > Gary H.
> >
> > -----Original Message-----
> >
> > >Can u get a screw driver under the loop and get it open enough to remove
> > >
> > >the bundle?
> > >Ollie
> > >----- Original Message ----- 
> > >From: "MO
> > >>
> > >> I am running this up again as I would like to get thr harness out 
> > >> soon.
> > >> It
> > >> may be obvious , but I have very low vision at this time- blind in one
> > >> eye
> > >> and can't see out the other! Hopefully another corneal transplant in
> > >> March. Thanks for any help.........................MO
> > >> ----- Original Message ----- 
> > >> From: "MO
> > >>
> > >>
> > >>>
> > >>> I am trying to remove the underdash wireing harness on my 64 Dodge
> > >>> 440--On each side of the steering colunm there is a bracket standing 
> > >>> up
> > >>> from near the bottom edge of the dash ( about 2" long. It looks like 
> > >>> a P
> > >>>
> > >>> with the harness going thrugh the loop in the top of the P. How do I 
> > >>> get
> > >>>
> > >>> the harness loose from that loop or take the brachet off the dash?
> > >>> Thanks
> > >>> for any help.............................MO
> > >>>
>
>
>
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and 
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.