Re: Questions on priming
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Questions on priming



Already, thank you to you and to Gary. We will check both in order... Making sure counter clockwise first, then the oil pump if that doesn't work... Thanks guys... I'll let ya know what happens.

Sent from my iPhone

On Oct 10, 2009, at 8:39 PM, tcellguru@xxxxxxx wrote:



sounds like maybe a piece of trash jamming the rotors/gears in the pump cavity, did you try turning it in reverse? I would drop the pan and see what it is, may end up somewhere ya don't want and it'll always be nagging at ya
in the back of your mind.


In a message dated 10/10/2009 9:30:40 P.M. Eastern Daylight Time,
64Polara500@xxxxxxxxx writes:

We are  trying to prime the engine using the priming shaft and drill.
It's not turning.... Any ideas you can give me would be  helpful...any
other ways to prime the enigine that anyone would  recommend?  We know
the engine turns.... Any thoughts, I would  greatly appreciate!!!

Thanks again!
Layne
64 Polara 500
413  Rebuilt



[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.