Re: Questions on priming

[Layne G <64Polara500@xxxxxxxxx>]

Again, thanks... We found it was our lack of knowing that we needed to  
go counterclockwise.  Thanks for your help... We will know next time...

Layne

Sent from my iPhone

On Oct 10, 2009, at 8:35 PM, Gary Pavlovich <glpavlovich@xxxxxxx> wrote:

> Layne,
>
> Make sure you are trying to turn the oil pump counter clockwise for  
> a big block; clockwise for a small block.
>
> Gary
> ----- Original Message ----- From: "Layne G" <64Polara500@xxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Saturday, October 10, 2009 6:29 PM
> Subject: Questions on priming
>
>
> > We are trying to prime the engine using the priming shaft and  
> > drill. It's not turning.... Any ideas you can give me would be  
> > helpful...any other ways to prime the enigine that anyone would  
> > recommend?  We know  the engine turns.... Any thoughts, I would  
> > greatly appreciate!!!
> >
> > Thanks again!
> > Layne
> > 64 Polara 500
> > 413 Rebuilt
>
>
> ----
> Please address private mail -- mail of interest to only one person  
> -- directly to that person.  I.e., send parts/car transactions and  
> negotiations as well as other personal messages only to the intended  
> recipient, not to the Clubhouse public address. This practice will  
> protect your privacy, reduce the total volume of mail and fine tune  
> the content signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. -- 
> ^----------------------------------------------------------------
> This email was sent to: 64Polara500@xxxxxxxxx
>
> u/?bUrDWg.cewd1o.NjRQb2xh