Re: Questions on priming

[tcellguru@xxxxxxx]

sounds like maybe a piece of trash jamming the rotors/gears in the  pump 
cavity, did you try turning it in reverse? I would drop the pan and see  what 
it is, may end up somewhere ya don't want and it'll always be nagging at ya  
in the back of your mind.
 
 
In a message dated 10/10/2009 9:30:40 P.M. Eastern Daylight Time,  
64Polara500@xxxxxxxxx writes:

We are  trying to prime the engine using the priming shaft and drill.    
It's not turning.... Any ideas you can give me would be  helpful...any  
other ways to prime the enigine that anyone would  recommend?  We know  
the engine turns.... Any thoughts, I would  greatly appreciate!!!

Thanks again!
Layne
64 Polara 500
413  Rebuilt



[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.