Re: Went to the shop and measured my pulley. 6 1/4 inch

[Don Dulmage <big-d@xxxxxxxxxxxx>]

I just went and looked till i found what I wanted. Could be it wasnt poly. I 
am getting old and it has been working now for many years. I didnt go 
looking for a specific pulley I went looking for a smaller one.
Don
----- Original Message ----- 
From: "Rich Kinsley" <rlkinsley@xxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Tuesday, April 28, 2009 5:49 PM
Subject: RE: Went to the shop and measured my pulley. 6 1/4 inch


> The overall outside dia of my stock poly pulley was 6.5" Hmmmm.
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
> =====================================================================
> Don Dulmage wrote:
> > 6 1/4 inch
> >
> > Measured it three times to be sure
> >
> > don
> >
> > [Non-text portions of this message have been removed]
>
>
>
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.