RE: chrome to body gasket

[62pluckedchicken@xxxxxxxxx]

Never mind... trick question..

Gary Goers got back to me.. this is a "prototype" gasket he created and 
it should have never gone out

He's sending new ones that can be used all in one piece

I'm gonna cut them an use the one I got, and use the new one when I get 
my car repainted... :)

62pluckedchicken@xxxxxxxxx wrote:
> 
> I got my tail light shrome back from the plater, and the rubber tail 
> light molding to body gasket, but not sure how to approach the gasket 
> installation
> 
> the rubber gasket has an area designed to go around the "wishbone" of 
> the chrome piece and straight pieces to edge the perimeter of the chrome
> 
> the problem is there is not a continuous slit to allow the rubber gasket 
> 
> to be installed in one piece (see 
> http://www.frappr.com/?a=viewphoto&id=5591207&pid=10967544 )
> 
> so do I take a razor blade and try and make the slit on the "wishbone" 
> piece meet up with the perimeter pieces, or do I cut the point off and 
> install the "wishbone" and perimeter pieces separately?
> 
> I should have taken a pic of the set up, before removing the chrome.. 
> now 6 weeks later, I haven't a clue how it was originally done :(


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.