I'm finally ready to start playing w/ the poly in my Coronet (Gary P - I'll be emailing you directly soon!) and I was wondering...is there an easy (read cheap too) way to convert a poly top end to hydraulic? I've always played w/ later small blocks and I REALLY LOVE the "bolt down the rocker shaft and go" approach to their top end setup. And since I've never had a solid lifter motor before this one, I really have no idea how long it's gonna take and how much effort goes into adjusting the top end...so I'm a little leery. Can any shed some light on this? Also, does anyone make a composite intake gasket for poly's? as opposed to those hateful stamped metal crush gaskets? Thanks in advance. Bill M 65 Coronet 500 'vert