Re: sway bar

["Dennis J." <djohn14296@xxxxxxxxx>]

Bob,
   I'm throwing this out for discussion, as I do not know for sure(
don't know anything about carburetors), but are not all the the 62
though 65 front ends the same?? If so and being the case a 65 one
should work on a 63???
   I'm sure someone with the correct books can tells us???
DJ


--- Bob Fortson <bobt1885@xxxxxxxxx> wrote:

> 
> I'm not having a lot of luck so far...plenty of kits
> for 65'3 and up but nothing for a '63 B body.
> 
> I want a "bolt on" front sway bar / mounts for my Fury
> convertible. Anybody got one ? Anybody know where to
> get one ?  I get enough body roll (in reverse of all
> things) to cause chunking of the tire edge...don't
> want to cut the fender.
> 
> Bob Fortson
> 
> 
>  
>
____________________________________________________________________________________
> Looking for earth-friendly autos? 
> Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.
> http://autos.yahoo.com/green_center/
> 
> 
> ----
> Please address private mail -- mail of interest to only one person
> -- directly to that person.  I.e., send parts/car transactions and
> negotiations as well as other personal messages only to the
> intended recipient, not to the Clubhouse public address. This
> practice will protect your privacy, reduce the total volume of mail
> and fine tune the content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 
> 



      Dennis
   


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.