Rich Kinsley '64 Polara 4 dr 318poly w/goodies I am still not satisfied with my trans shifting. It feels like it wants to creep in neutral and the kickdown is practically non-existant. I have managed to get the neutral safety switch working again. I moved the adjustment clockwise one "hole" yesterday and I believe it is better. I also tightened the kickdown cable about 1/4". I had it so that there was no slack before. I think I'll try one more notch clockwise and see if it's better still. I had gone one "hole" counterclockwise and it was noticeably worse. Nobody I have found around here has a clue about the adjustment on the buttons. I previously tightened the button mechanism and that had shown a great improvement too. There were some loose nuts/bolts in it when I checked. If I have any real problems I may take a drive over to Lincoln where it was rebuilt as that guy knows these cars. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx bSONJP. Or send an email to: 1962to1965mopars-unsubscribe@