Re: Superstock Springs

[Jeff Mullen <dodge65500@xxxxxxxxx>]

did you customize your front hangers by redrilling the
holes 1" farther back? or is that just the MP SS springs?

--- John <moparbikeguy@xxxxxxxxxxxx> wrote:

> [AD removed for archives]
>
-------------------------------------------------------------------
> Ben & Jerry?s® or Häagen-Dazs®?
> Take our Nationwide Ice Cream Survey today! Receive a
> FREE* $100 
> Restaurant Gift Card of your choice or $100 worth of Ben
> & 
> Jerry?s® or Häagen-Dazs® ice cream for participating!
> caadVYQb5qRHYa/Ice Cream
> Research Survey
>
-------------------------------------------------------------------
> 
> 
> I just finished installing a new set of superstock
> springs and all the related parts (hangars, shackles, U
> bolts, long shocks)in my '65 Coronet. I noticed that
> after torqueing down the right spring U bolts, the pad on
> the left axle tube was not touching the spring in the
> front, only the back of the pad was touching. It was off
> by a good 5 degrees. I took everything apart, checked
> everything with an angle finder, and it seems that the
> spring are at different angles where the axle tube sits;
> the axle is OK. I torqued everything down to factory
> specs, and everything tightened into place, but it just
> doesn't seem right. Has anyone else had a problem like
> this, or is this normal pre-load?
> -- 
> '65 Coronet 500
> 500 CID Wedge



		
__________________________________ 
Yahoo! Mail - PC Magazine Editors' Choice 2005 
http://mail.yahoo.com