Re: Mopar Tapoered Axle Brake Coversion Link

["Dennis C." <dennis.2914@xxxxxxxxx>]

No,

Just the complete differential.

Dennis

On Thursday, September 4, 2014 6:57:12 AM UTC-7, 62to65mopar wrote:

Thanks Dennis. I agree swapping the entire rear drum to drum is very doable. The question, though, was installing non-tapered axles in a tapered axle housing. That is what you did?

Thanks,
Gary H.

>  -------Original Message-------
>  From: Dennis C. <denni...@xxxxxxxxx>

>  -------Original Message-------
 
>  
>  OK,
>  
>  I am the third that says it can be done - I did it - just a bolt in swap.
>  
>  1965 Coronet from a station wagon into my 1963 Plymouth Sport Fury with a
>  383 and Borg Warner 4-speed.
>  
>  All I did was clean it up, new bearings and seals, checked the internals
>  and bolted it in.  ...

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.