Re: Exhaust "bypass" valve? Also..timing

[Eric Sturgis <ericsturgis@xxxxxxxxx>]

Oh about the exhaust bypass valve, I would not remove it, I would just
take some steel wire and wire it open so it doesn't rattle and bother
you.  If it is leaking and making noise from the exhaust leak then you
will have to take it off and deal with it, but I'd just live with it,
it's a bit of a pain as rusted on exhaust bolts tend to not be
friendly.  If you do have to take it apart make sure to use LOTS of
penetration oil to soak the bolts to help get them out.
-- 
Eric
Tacoma, WA
1962 Chrysler Newport 2 door HT

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.