A833 bearing retainers

[Jeff Adams <ledman_70@xxxxxxxxxxx>]

Hey guys, I'm gettng ready to put an 833 OD into my 64 Polara to replace 
the 833 already in there, which I think has the 4.3" retainer. What I'd 
like to know is if the bolt circle on the OD trans bearing retainer, 
which I think is 5.25", is the same as the bc on the 4.3" retainer. If 
not, how hard would it be to drill/tap the front of the OD trans to fit 
the 4.3" retainer? If I can't do that, then I'll have to have the bell 
housing machined to fit the big br, and that would keep me from being 
able to go back to the small br if I blow up the OD trans. Confused 
now?? I am! 


Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.