Re: Engine Turning Trim

[John Hammond <426_maxwedge@xxxxxxxxxxx>]

It's out there - I had an ad flyer on it at one time, try Bill's Special-T's 
I think...
John Hammond
----- Original Message ----- 
From: "Nick Tiberio" <furyus63@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Wednesday, July 29, 2009 5:49 PM
Subject: Engine Turning Trim


> Does anyone know of a vendor that can supply the (engine turning
> jeweling) tape trim for the the side moldings on a 1963 Sport Fury.
>
> Also looking for a set of rocker panel moldings & clips for a 1963 Sport
> Fury.
>
> Nick Tiberio
> furyus63
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.