Re: {Chrysler 300} 300G antenna hole on fender.

The non-power antenna was installed at the dealership so they can vary in location. They had a bulletin with the template.

Here is a page on the club site that shows the template for 1962 Chrysler, which is probably the same for 1961.

https://chrysler300club.com/tech/mirror/template.html

On Wed, Aug 14, 2024 at 12:06 PM Jean-Yves Chouinard <jymopar@xxxxxxxxxxx> wrote:

Hello to all in 300 land.

Can anyone confirm the location of the pass side fender hole for a radio antenna please.

My fender antenna hole looks to have been made rather crudely, so I just want to make sure it is located at the right place before getting the fender painted...

The center of the hole on my fender is about 16 1/8 inch from the rear pointed fender tip (measured in a straight line) and about 6 ¼ inch from the inside edge.

Thank you.

Jean-Yves Chouinard.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/LV8P222MB1309BD38BD39D9CCAB877FE0AE872%40LV8P222MB1309.NAMP222.PROD.OUTLOOK.COM.