Re: {Chrysler 300} F Manifold

Phone

On Aug 10, 2022, at 7:45 PM, mark love <marklove@xxxxxx> wrote:

It won’t matter much that we have a terrific welder in Calgary Alberta who welds cast (and everything else) welded my cast exhaust manifold when the g d muffler shop hung the exhaust off the manifolds while they were wrestling them into alignment and fastening them down. Can’t account for stupidity. But it’s Trillium Industries in Calgary if you wanna ship it up and have them do it. It was the outside ‘ear’ on the leading port and they got it.
M.

On Aug 10, 2022, at 7:38 PM, Ron Waters <ronbo97@xxxxxxxxxxx> wrote:

Also agree. They only time I've heard of successful cast iron welding is when it involved a cracked block. With a block, there's plenty of 'meat' to work with, so you can cut a V-channel into it before beginning the welding process. For an exhaust manifold, you're done for.

Ron

From: chrysler-300-club-international@xxxxxxxxxxxxxxxx [mailto:chrysler-300-club-international@xxxxxxxxxxxxxxxx] On Behalf Of dplotkin@xxxxxxxxxxxxxxxxxxx
Sent: Wednesday, August 10, 2022 9:10 PM
To: Ryan Hill
Cc: 93saturnfan; chrysler-300-club-international@xxxxxxxxxxxxxxxx
Subject: Re: {Chrysler 300} F Manifold

I'll second that. You will be well advised to spend time seeking a replacement than a welder. The fellow who proposed JB Weld, an epoxy, a plastic, must have been kidding. I hope so.

Dan
-----Original Message-----
From: "Ryan Hill" <ryan_hillc300@xxxxxxxxxxx>
Sent: Wednesday, August 10, 2022 9:04pm
To: "93saturnfan" <93saturnfan@xxxxxxxxx>
Cc: "chrysler-300-club-international@xxxxxxxxxxxxxxxx" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Subject: Re: {Chrysler 300} F Manifold

In my opinion, the task is nearly impossible. There has been discussion on this topic in the past and I don’t recollect anyone having more than short term success with a manifold. The process requires the manifold to be heated to an almost molten state before a weld can be successful.

Ryan Hill

On Aug 10, 2022, at 3:56 PM, 93saturnfan <93saturnfan@xxxxxxxxx> wrote:

Well I received a call from the welding shop I took my broken manifold to today. They were able to weld it together but upon striking it with a hammer to make sure it held, it cracked again. Then the welder suggested I use JB weld to fix it. I don't know if it cracked along the weld or elsewhere as I haven't seen it yet but I plan on picking it up tomorrow and taking my business elsewhere.
Does anyone in the Midwest or Southeast Wisconsin area have any recommendations of a welding place that can handle a cast iron manifold?

Thank you in advance.

Ryan Stevenson

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/77EF15DB78664DCD89A6095E2209AF8D%40ThinkPadL520.