Re: [Chrysler300] 300J and Ram K Valve Covers

["Keith Langendorfer keith_A_Lang@xxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Thanks, Carl. Does anybody reproduce these or a usable facsimile? 

If not, does anyone in the club have a set they’d care to sell?

Thanks!

Keith

On Jun 19, 2019, at 12:00 AM, Carl <cbilter@xxxxxxxxx> wrote:

Not tack welded.  Held on lower v.c. studs by the nuts.  J/Ram K uses three instead of four.  Passenger side front is not used as the #2 and #4 wires are secured in a bracket that is mounted on the first exhaust manifold stud.

 

Carl Bilter

J consultant

 

From: Keith Langendorfer keith_A_Lang@xxxxxxxxx [Chrysler300]
Sent: Tuesday, June 18, 2019 9:14 PM
To: Chrysler300@xxxxxxxxxxxxxxx
Subject: [Chrysler300] 300J and Ram K Valve Covers

 

 

Hi Folks

Do the J and Ram K valve covers have the same ignition wire guide plates tacked welded to the valve covers as the 1964 413/360 engines? I’m converting a 413/360 four speed K to a short crossram and would like to know

Thanks!

Keith
Maine

 

<2E04BAED8A7447488F94A78E773B74B2.png>

__._,_.___

---

Posted by: Keith Langendorfer <keith_a_lang@xxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___