Re: [Chrysler300] Throttle dash bracket plastic
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Throttle dash bracket plastic

You can Machine this type of bushing from Delrin at low cost . Might need a snap ring instead of force fit . Had to do that for Ford stick shift linkage ( 57) rubber grommets they use are junk . ( why ford stick on column is all loosey goosey) Better than nylon . Find a small machine shop , with measurements of metal parts . 

Sent from my iPhone

On 5 Aug 2018, at 9:08 pm, Charlie V cv300g@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

I know that Gary Goers is trying to get out of business, and maybe he has already called it quits, but he has them in his catalog. I do not have his catalog in front of me to give you his part number.

That is if its the nylon bushing on the bracket bolted to the rear of the engine that has the horizontal portion of the throttle shaft. This part of the throttle shaft is parallel to the fire wall.

Charlie Valentine

On ‎Sunday‎, ‎August‎ ‎5‎, ‎2018‎ ‎07‎:‎15‎:‎40‎ ‎PM‎ ‎EDT, Larry Jett LarryWJett@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:


On single carb 413's for both 63 and 64 C bodies, there is a little  C shaped  plastic bearing and rod locater that is broken on Angad's 300K

There is no part number for it as it is included in the 2205-820 engine side throttle linkage bracket.  Perhaps Murray can get me a used one but does anyone know of a reproduction?


Posted by: John Grady <jkg@xxxxxxxxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap

Copyright 2018 The Forward Look Network.  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.