RE: [Chrysler300] 413 Pistons
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] 413 Pistons





Thank you for all the replies.

 

Customs are always a choice (an expensive choice) and was wondering about off-the-shelf ones.

 

The 10:1 piston is not a problem as various expedients such as the range of head gasket thicknesses alone allows some fine tuning. With Mopar's head spacer package P4529099 the .060 shim drops it about a full point.

 

With an engine that will be at less than 10:1 static compression and won't be raced, are cast pistons sufficient?  What results have people gotten from using Egge  pistons? I know there has been mention of some people using them. As far as Rebuilder's Choice has anyone used them and what was the experience, good, bad, indifferent? Looks like Rebuilder's choice may have some connection to Kanter

 

If I need new pistons and cast pistons won't do, so be it.  I'll have to either go custom or find some alternative.

 

 



__._,_.___

Posted by: "Richard Vitek" <rpvitek@xxxxxxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.