{Chrysler 300} Setting transmission throttle lever.

["'Richard McFarland' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Is there a tried and true way to set the throttle lever on a 63 727 ? The service manual says to set it with the lever forward at the stop. With no throttle ( where it is at idle). I did this and it shifts perfectly according to the speed chart in the book. Problem is it won’t kick down. I have read forums that say to adjust it with the accelerator all the way down ( full throttle) and the kick down all the back at the stop. Just can’t get it right that way either. Which is it or is there a trick I’m missing ? My fall back is have the kick down inoperable because it shifts so good and I don’t hot rod it. Not sure what to do. Can’t imagine it could hurt the trans to not kick down, but this is my first Mopar. Thanks for any help!

Sent from my iPad

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/C136B815-F766-4074-8AF2-4F90CFF87550%40yahoo.com.