[Chrysler300] Ball and Trunnion

["Richard Osborne" <richard@xxxxxxxxxxxx>]

Good Morning,

I just put the G up on a lift to "nut and Bolt" it, ensuring that all
is tight prior to its first major drive next week, to the Michigan Meet.
All looked good except I found the ball and trunnion to have much more
"slop" than I would care for. 

I know these have been hard to find, but I thought I remembered someone
stating a while back that there was a new supply of these? Was it Andy
Bernbaums' (sorry for the spelling)?

Does any one have a set that may be going to the MI Meet that is
willing to sell? Does the drive shaft need to be balanced after
replacing this? Can I swap this out in the parking lot?

Thanks for your help. This drive shaft was supposedly rebuilt while I
had the car apart for restoration. 

Best regards,

Richard Osborne
Cols. OH


------------------------ Yahoo! Groups Sponsor --------------------~--> 
Help save the life of a child.  Support St. Jude Children's Research Hospital's
'Thanks & Giving.'
http://us.click.yahoo.com/6iY7fA/5WnJAA/Y3ZIAA/8LmulB/TM
--------------------------------------------------------------------~-> 

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/