Fw: [Chrysler300] 300 G Heater Control

["Antonello Jelitro" <mopar@xxxx>]

> Hello from Italy
> I got my rebuilt one for my G from Jeff Carter. His address is on the link
> page of our website. He rebuilt mine, rechromed the bezel and painted the
> small arrows. Very nice job
> Antonello Jelitro
> ----- Original Message -----
> From: "Lauren R Lampi" <lrlampi@xxxx>
> To: <Chrysler300@xxxxxxxxxxxxxxx>
> Sent: Wednesday, July 02, 2003 8:09 PM
> Subject: [Chrysler300] 300 G Heater Control
>
>
> > Hi 300 Group,
> >
> > Need some help with the heater control block for a 300G ,Non Air.
> > This is the Plastic, 5 button control block, for the vaccuum lines
> > and electric connectors.
> >
> > Part number 2096083
> > For five push buttons from the front
> > and 7 vaccuum hose connectors on the back.
> >
> > It is about 3 7/8" wide, 1 1/4' deep, 1' high.
> >
> > Three of the vaccuum connectors on the back of the block
> > have broken off. Old age and stress????
> > I have the broken off pieces.
> >
> > Are there NOS, good used, Repro ones out there???
> > Or can I repair the one that I have???
> >
> > Can you "glue, epoxy, cement" the little vaccuum connectors
> > back on and will it work well enough??
> >
> > I think there was some discussion about this part and repair
> > one or two years ago.
> >
> > Any help would be appreciated.
> >
> > 300ly
> > Lauren R Lampi
> > 300G under construction
> > (Yes, This is the one that was rear-ended by a boat while it
> > was locked in my garage)
> > Grand Rapids, Minnesota
> >
> >
> >
> > To send a message to this group, send an email to:
> > Chrysler300@xxxxxxxxxxxxxxx
> >
> > For list server instructions, go to
> http://www.chrysler300club.com/yahoolist/inst.htm
> >
> > To unsubscribe from this group, send an email to:
> > Chrysler300-unsubscribe@xxxxxxxxxxxxxxx
> >
> >
> >
> > Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
> >
> >
> >
>
>