Re: [Chrysler300] Questions

["obiwan10" <obiwan10@xxxx>]

I had similar leak in my B's torqueflight. Replaced small "O" ring seal on push button control cable and all was well. No need to remove transmission for this. I would clean off bottom of transmission and try to determine where leak was coming from before removing it.

However did end of replacing transmission for another reason(very long complicated situation). Timo Tanskanen provided me an excellent rebuilt replacement. Couple of other good transmission builders in the Club also.

Roger Schaaf
300 B Calif
----- Original Message ----- 
From: pennsy300@xxxx 
To: chrysler300@xxxxxxxxxxxxxxx 
Sent: Friday, April 11, 2003 11:09 AM
Subject: [Chrysler300] Questions


Hey, you transmission weenies out there, I've got a question. The 
transmission on my D convertible leaks, nearly a cup a week just sitting in 
the garage, until the fluid level gets about a quart and a half low. I'm 
getting tired of the mess on the floor, so I'm gonna have it fixed. Now the 
question: can the transmission be removed from the car without removing the 
engine? Remember, this is a convertible, so it has the massive X-frame 
addition to the normal ladder frame. And since I've got your attention, what 
lubricant should I use in the D's real axle, given that it is a limited slip 
unit? Thanks for whatever help I can get. McTaggart

Yahoo! Groups Sponsor 
ADVERTISEMENT




To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 

To unsubscribe from this group, send an email to:
Chrysler300-unsubscribe@xxxxxxxxxxxxxxx



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


[Non-text portions of this message have been removed]